expect a T4 about 1/3 of an inch thicker, and about 5-6oz heavier
On a good note expect 6k60 and 10bit internal
anamorphic ratio
fully articulating flippy…essentially an S1H but APSc with Fuji color and obviously much smaller
release end of 2020
I don’t know if this is correct. Surely IBIS sounds plausile, as Fujifilm managers repeatedly said, that they work on making the IBIS unit smaller, so that they can fit it into other (not X-H) X series cameras
Where I disagree, though, is Jason’s report that the Fujifilm X-H2 will never come. To my knowledge, the X-H2 will come!
X-LR is a Lightroom plug-in that reads Fujifilm’s Film Simulation from your RAW file and automatically applies corresponding profile when you import your images to Lightroom.
One big issue it fixed is that Adobe quietly introduced new film simulation profiles with a v2 suffix for the X-T3 and now the X-T30. This release addresses that change and supports any new Fuji cameras for which Adobe introduce v2 profiles.
It has other improvements too:
Supports Adobe’s v2 profiles for X-T3 and X-T30 cameras
Support for X-H1 Eterna film simulation
Extracts maker notes as custom fields
Can run a preset if the camera detected faces
Read ratings and film simulations from JPEG-only shots
Expert Mode
Incremental Lightroom slider values
Ranges of values – eg FacesDetected tag greater than 1 can apply a portrait preset
Notice how that they mostly focus on shooting experience, rather than pixel peeping. And honestly that’s kind of refreshing, as we usually are bombarded with charts, crops and comparisons when a new camera comes out.
Seen from this perspective, the Fujifilm X-Pro3 already achieved what it’s ment for: focus on feel and experience, rather than technical specs.
In case of Gordon (Cameralabs), he says the hidden screen helped him to review images and access menus way less than he normally does. He says:
Previously I always preferred the X-T series over the X-Pro series. But with the X-Pro3 I was surprised just how refreshing and enjoyable I found the experience, how little I worried about settings or features and how much I’d like to shoot with it again.
The Features
With that said, of course the reviewers also go over the new features of this camera.
For example, Gordon from Cameralabs shows samples of the new HDR plus mode, a feature that Gordon says “makes a really good job”. Press the shutter once, and the camera takes three images and combines them into one HDR image (see images below). It works used handheld.
Oh… and Gordon LOVES the new Classic Negative film simulation.
Now let’s cross fingers that all the X-Pro3 firmware goodness on the X-T3, X-T30 and GFX100.
As you know, the optical viewfinder on the “old” X-Pro2 had a build-in 0.36x and 0.60x magnification modes. So, when you use let’s say a 35mm lens, in order for your frame not be too small in the viewfinder, you could switch to the 0.60x magnification.
This is no longer possible with X-Pro3, as it has a fixed OVF magnification of 0.52x.
However, Gordon says that the overall much bigger optical viewfinder on the X-Pro3 helps to compensate for the lack of 0.60x magnification.
For your convenience, down below I have extracted and overlayed both viewfinder frames at 23 and 35 so you get a clear idea how big the difference really is.
With all that said, check out the Fujifilm X-Pro3 review roundup below.
